Browse the parts catalogue

Rear-Console AC Duct Adapter designed for the 2010 Toyota Highlander / Kluger (XU40). Exact 2010 fit to 3 by 6 inch rear center-console vent.

Liftgate 3.5-inch Speaker Adapter designed for the 2018 Toyota Highlander / Kluger (XU50). Exact 2018 liftgate fit

Console Cupholder Yeti Adapter and Coin Tray designed for the 2011-2017 Toyota Camry (XV50). Author states it fits the 2016 Camry cupholder and pictured Yeti cup. Accessory with cup-specific fit.

Dash-Pocket Cupholder Adapter designed for the 2001-2006 Toyota Camry (XV30). Designed for the square dashboard pocket under the radio on a 2004 Camry. Accessory

A printable hybrid dash phone-mount adapter documented by the original creator for 2019 Corolla Hybrid Toyota Corolla fitment. Creator specifies PETG for cabin heat.

A printable rear 6x9 speaker adapter documented by the original creator for 2013-2015 Corolla Toyota Corolla fitment. Rear-speaker package/market variation may matter.

A printable 6.5-inch pioneer door-speaker adapter documented by the original creator for 2004-2009 Toyota Prius fitment. Three vehicle mounting holes align in only one orientation.

A printable headlamp-leveling actuator adapter documented by the original creator for 2004-2006 Toyota Prius fitment. Source says headlamp disassembly is required

A printable post-refresh vent phone-holder adapter documented by the original creator for 2015-2020 Toyota Sienna fitment. Tested in a 2016 Sienna

Audiocircle Dashboard Speaker Adapter for Toyota 86 / GR86, mapped to the ZN8 generation based on the source fitment information. Source explicitly says 2022 BRZ

Odyssey-PC680 Battery Adapter for Toyota 86 / GR86, mapped to the ZN8 generation based on the source fitment information. Source explicitly states 2022/2023 GR86/BRZ

Dashboard Speaker Adapter Set for Toyota 86 / GR86, mapped to the ZN6 generation based on the source fitment information. Source explicitly identifies GT86/FR-S/BRZ and includes a rainshield.

Front-Door Speaker Adapter for Toyota 86 / GR86, mapped to the ZN6 generation based on the source fitment information. Use tested V06 only

Adapter for installing Audi switch 8D0941563 in the right-hand-drive Toyota Supra Mk4 right-side centre-panel switch position

Adapter that uses the factory three-point front-speaker mounting holes in a fourth-generation Toyota Supra to install a four-inch speaker without modifying the original enclosure

Adapter ring designed for a first-generation vehicle to install a smaller replacement speaker in the factory speaker location.

Centre-console adapter sized to hold a one-litre wide-mouth bottle upright in a 2015 cabin.

Adapter that routes a retractable tonneau-cover drain hose through the factory bed drain.

Two height options for angling a threaded oil funnel away from surrounding engine-bay components.

Four-sided insert that centres a 14-ounce handled tumbler in the 2017 middle console cup holder.

Drain fitting that joins the tonneau-cover hose to the factory bed drain without drilling.

Adapter that secures the 2016-and-later ignition key blade in a folding key-organiser body.

Centre-console switch blank replacement that accepts an RJ-series keystone connector for radio or data wiring.

Clip-in adapter for fitting a dual-USB extension socket into a factory dashboard switch opening without modifying the original trim.