Toyota FJ Cruiser 3D-printable parts

Replacement knob for the FJ Cruiser heater and air-conditioning controls, retained with an M3 socket-head screw.

Fitted removable cover for the open centre-console box, with a cable-routing gap and clearance for levelling pads.

FJ-specific PanaVise mounting plate for a Baofeng F8HP or smaller handheld radio, supplied in tapped-hole and heat-set-insert variants.

Two-piece replacement centre cap for the cabin armrest, assembled with an M3 by 8 mm screw.

Three-piece replacement shell and button insert for the 2007 FJ Cruiser remote-key electronics.

Flat-faced replacement dashboard and console switch blank with clear rear space for installing a small switch, indicator or accessory.

Two sizes of fitted roof-panel plugs for covering the factory roof-rack mounting openings on the 2007 FJ Cruiser.

Replacement hinged cover for the cabin 12-volt cigarette-lighter power outlet.

FJ-specific centre-console storage sleeve with a phone-sized main pocket and optional small bottle and gum-container attachments.

Heat-resistant replacement cap for the exposed windshield-wiper arm pivot fastener.

Replacement trim plug for the automatic-transmission gear-selector assembly.

Replacement protective grille for the FJ Cruiser snorkel intake, with standard and flat-backed printable variants.