Toyota Hilux 3D-printable parts

Replacement translucent lens for the shared interior room-lamp assembly used on 1984–1995 pickups.

Replacement retaining clip for securing the sun visor in its stowed position.

Clutch-alignment dummy shaft for KUN26R vehicles equipped with the 1KD-FTV engine.

Four-piece organiser for the centre-console opening with two upright phone slots and a separate coin pocket.

Repair set containing a bonnet-prop-rod retaining catch and a front-grille screw clip, designed from a 1987 four-wheel-drive pickup.

Flexible replacement plugs for the rectangular access openings in the two-wheel-drive pickup frame.

Textured replacement handle and knob for manual window regulators, assembled with a one-inch drywall screw.

Replacement storage-box insert for the small opening below the outer dashboard vent, designed from a 1986 pickup.

Replacement mounting base that uses the original roof-hole pattern to install a functioning dome light, designed from a 1988 pickup.

Block-off plate for sealing the unused air-conditioning openings in the firewall, designed from a 1987 pickup.

Freestanding cup holder shaped to fit between the bench seat and gear lever.

Two-piece replacement knobs for the dashboard heater controls, with contrasting insert pieces for the indicator markings.

Replacement knob for the manual window crank, designed for attachment with a 10-24 by one-half-inch button-head screw.

Replacement intake cover for the accessory snorkel, with additional retention clips and compatibility with the original cover mounting geometry.

Replacement corner and side support brackets for the factory-style tray tonneau-cover support structure.

Three-piece replacement shell, rear cover and flexible button insert for the B41TA-style two-button remote key.

Splined clutch-alignment dummy shaft for TGN16R vehicles equipped with the 2TR-FE engine.

Replacement outer knob and internal drive geometry for the manual climate-control panel.

Two-piece phone cradle and CD-slot mount sized around Samsung S8 Plus and S9 Plus phones in LifeProof cases, with side access for a charging cable.

Two-sided replacement hinge that clamps around the retained metal hinge bar in the glovebox, designed from a 1986 pickup.

Replacement faceplate for the dashboard heater-control sliders, designed from a 1987 pickup.

Replacement wing nut for retaining the original air-cleaner assembly, designed from a 1988 pickup.

Replacement knob for the heating and air-conditioning controls, designed from a 1984 pickup.

Replacement support bracket beneath the four-wheel-drive selector trim and centre console on right-hand-drive vehicles, supplied as a one-piece model and a support-reduced two-piece alternative.