Toyota Land Cruiser 60 Series 3D-printable parts

Two-piece replacement fuse-box cover with raised fuse-position text, modelled from a damaged original cover.

Bushing located at both ends of the rod connecting the wiper motor to the wipers. Print in plain nylon for best results. Video of install here: https://youtu.be/1ZTh9ZuZpTM?si=5zUaRD01rmpsLkAI

Replacement plastic captive nuts for securing the grille, headlamps and front running lights. The creator recommends weather- and heat-resistant material.

Bracket for installing a 2 1/16-inch Speedhut or similarly sized 53 mm tachometer in the original instrument cluster.

Clip for mounting a 31 mm Element fire extinguisher, flashlight or similar cylindrical item to a 26.1 by 4.9 mm seat-bracket crossbar.

Left- and right-hand two-piece inner housings for repairing brittle side-marker assemblies, with alternate bulb-socket openings and blank editable socket source.

Three blanking-plug variants for the small and large dashboard switch openings, including a small plug with a centre hole.

Three replacement plastic fasteners for the grille, lamp and bulb-holder positions on a 1987 vehicle.

Replacement grommet and retaining catch for the bonnet support rod. The creator recommends weather- and heat-resistant material.

Replacement interior-light cover and flexible gasket for fitting a low-cost LED panel in place of the original lamp assembly.

Pair of rails for replacing the ashtray with a CB radio or another accessory approximately 115 mm wide.

Insert for the front compartment of the factory centre console, with two 72 mm cup recesses and a vertical phone slot.