Toyota Land Cruiser 3D-printable parts

Two-piece replacement fuse-box cover with raised fuse-position text, modelled from a damaged original cover.

Bushing located at both ends of the rod connecting the wiper motor to the wipers. Print in plain nylon for best results. Video of install here: https://youtu.be/1ZTh9ZuZpTM?si=5zUaRD01rmpsLkAI

Replacement access door for the factory-style cabin-filter retrofit opening in the evaporator cover. This version is slightly oversized for an opening cut to the moulded guide line.

Three ashtray-replacement panel variants for adding rear-seat USB outlets, including switched and mirrored switched layouts.

Factory-style switch-blank panel for a flush-mounted combined USB and 3.5 mm auxiliary extension socket.

Replacement latch for the storage box between the front seats.

Replacement plastic captive nuts for securing the grille, headlamps and front running lights. The creator recommends weather- and heat-resistant material.

Blanking cover for the third-row ashtray opening when the original tray cannot be retained.

Middle- and side-vent repair inserts that replace crumbled pivot plates and provide new pins for drilled vent vanes.

Workshop socket for removing and installing the radio-antenna retaining nut.

Workshop socket for adjusting the differential side-bearing nut, modelled for a 1991 vehicle.

Replacement internal drive gear for the powered radio antenna assembly.

Bracket for installing a 2 1/16-inch Speedhut or similarly sized 53 mm tachometer in the original instrument cluster.

Rear support bracket for the power-seat threaded drive rod. The creator recommends full infill and notes that the centre bore may need adjustment.

Replacement latch for the fuel-filler door.

Deeper replacement pocket for the opening above the stereo, with a rear cable pass-through.

Three cup-holder insert variants for the square centre-console opening, including a larger rounded recess and a version with an accessory slot.

Replacement blanking plug for unused rectangular dashboard switch positions.

Replacement release lever for the lower tailgate, supplied with editable STEP source. The spline fit may need adjustment for individual printers.

Hands-free funnel that screws into the 37 mm by 3 mm-pitch oil-filler opening on the 1FZ-FE engine, keeping it seated above the rocker-cover baffle.

Threaded replacement cap for the power-seat drive screw.

Panel for installing a USB socket beside the rear-heater switch or in place of the coin holder in the centre console.

Separate front- and rear-door spacers for installing 8-inch aftermarket speakers while preserving window-glass clearance.

Five-piece replacement for the original small cup holder, split for compact printers and designed for larger cups and bottles. The left- and right-hand upper pieces can be mirrored for left-hand-drive fitment.