Toyota RAV4 3rd Gen 3D-printable parts

Five-piece mounting system for centring an aftermarket reverse camera beneath the third brake light on the 2006–2012 RAV4. It reuses the factory screw locations, clears the rear wiper, and was tested through an automatic car wash.

Drop-in coin organiser for the upper centre-console compartment of the 2007–2012 RAV4. It keeps coins sorted and prevents them falling into the lower compartment

Drop-in spacer that reduces the oversized cup-holder opening in a 2011 RAV4 so common drink containers are held more securely.

Clip-on seat-back hook made and used on a 2006 RAV4 for carrying small bags, packets or a light rubbish bag.

Replacement parcel-shelf mounting piece for the 2006–2009 RAV4 rear cargo cover.

Replacement trim cover for a seat mounting point on the 2006–2012 RAV4 XA30.

Test-printed replacement clip for the centre console of a 2008 RAV4, designed after the original clip broke.

Drop-in centre-console organiser sized to hold a lip-balm tube upright in the 2006–2012 RAV4. Use a heat-resistant cabin material

Drop-in phone holder for the small pocket beside the parking brake in a 2010 RAV4, sized for an iPhone 6 in a low-profile case and positioned near the auxiliary socket.

Protective grille for an eight-inch custom subwoofer installation in a 2006 RAV4.

Replacement flexible button pad for the remote key used with the 2006 RAV4. The author printed it in flexible TPE at full infill.

Replacement panel for the stock auxiliary-input position in a 2011 RAV4, adding both USB power and auxiliary audio without permanent vehicle modification. It is designed around the author's documented USB adapter and uses two 25 mm M3 screws.