Exterior — 3D-printable Toyota parts

Replacement grommet and retaining catch for the bonnet support rod. The creator recommends weather- and heat-resistant material.

Replacement mounting bracket for the rear camera.

Replacement internal drive gear for the powered radio antenna assembly.

Three-piece brace, locating ring and locking wedge for mounting a 175-amp electrical quick-disconnect socket in the grille on 1990–1995 vehicles.

Three-piece brace, locating ring and locking wedge for mounting a 50-amp electrical quick-disconnect socket in the grille on 1990–1995 vehicles.

Clip-on brace that holds the rear hatch fully open when worn gas struts can no longer support it.

Replacement bushings and keeper for the upper rear-hatch gas-strut mounting pin, with factory-style and revised versions.

Replacement body-pressure vent with sliding closure, fixed-cover and drain-tube versions.

Bracket for attaching a small auxiliary light to the factory roof rail, with an integral wiring channel and cable-management loops.

Replacement 10 mm square plastic body grommet for number-10 screws used on exterior trim such as side-marker lamps.

Replacement clip that secures the front grille to the body.

Replacement centre cap for the original alloy wheel.