Exterior — 3D-printable Toyota parts

Bushing located at both ends of the rod connecting the wiper motor to the wipers. Print in plain nylon for best results. Video of install here: https://youtu.be/1ZTh9ZuZpTM?si=5zUaRD01rmpsLkAI

Windshield Washer Fluid Cap designed for the 2001-2006 Toyota Camry (XV30). Made specifically for a 2005 Camry washer reservoir. Potential overlap with exact-number cap 3885990

Windshield Washer Jar Cap designed for the 1991-1996 Toyota Camry (XV10). Author modeled and tested the cap from an original, names exact Toyota the documented Toyota service number, and lists 1994-2006 Camry applications.

Windshield Washer Reservoir Cap designed for the 1986-1992 Toyota Camry (V20). Modeled as a replacement for the 51 mm washer reservoir neck on a 1990 Camry. TPU replacement

A printable rear-wiper shaft cap documented by the original creator for 2009-2015 Toyota Prius fitment. Source 4623620 appears to be a near-duplicate by the same creator

A printable washer-reservoir seal documented by the original creator for 2003-2009 Toyota Prius fitment. Reviewer should inspect files/photos and confirm which reservoir interface is sealed.

Wiper-Cowl Corner Repair Insert for Toyota MR2, mapped to the W20 generation based on the source fitment information. Source explicitly says it repairs broken corner mounts on 1990-1999 Toyota MR2 wiper cowls. Repair insert is not the complete factory cowl

Heat-resistant replacement cap for the exposed windshield-wiper arm pivot fastener.

Replacement cap for the windscreen-washer fluid reservoir, modelled and tested on a 2001 vehicle.

Replacement trim cover for the windscreen-wiper arm pivot.