Interior — 3D-printable Toyota parts

Two-piece replacement fuse-box cover with raised fuse-position text, modelled from a damaged original cover.

Tested replacement glovebox handle for the 2013 Toyota RAV4, intended as a functional interim replacement and recommended by the author for a solid print.

Factory-style switch-blank panel for a flush-mounted combined USB and 3.5 mm auxiliary extension socket.

Dashboard-Shelf Magnetic Phone Mount designed for the 2014-2019 Toyota Highlander / Kluger (XU50). Source identifies newer Highlander's dashboard shelf/USB-cover opening but omits year

Snap-on covers for the reflective chrome climate-vent rings fitted from the 2014 facelift.

A printable mfd screen sun visor documented by the original creator for 2004-2009 Toyota Prius fitment. Use heat-resistant material

Contoured spacer mount for attaching a ScanGauge II to the curved upper steering-column trim.

Driver-side and passenger-side replacement adjusters for the two central dashboard air vents.

Dashboard Speaker Adapter Set for Toyota 86 / GR86, mapped to the ZN6 generation based on the source fitment information. Source explicitly identifies GT86/FR-S/BRZ and includes a rainshield.

Replacement casing for the remote key used on Toyota RAV4 models from 2000 through 2006, covering the second-generation XA20.

Pull-out coin drawer sized for an unused dashboard switch opening.

Backing plate contoured to the dashboard side trim for mounting a GME MB206 or MB207 radio-microphone holder

Middle- and side-vent repair inserts that replace crumbled pivot plates and provide new pins for drilled vent vanes.

Cassette-Deck iPhone 6 Holder designed for the 2001-2007 Toyota Highlander / Kluger (XU20). Explicit Kluger/Highlander factory tape-deck interface

Radio Volume Knob designed for the 1996-2001 Toyota Camry (XV20). Author printed it to replace the volume knob in a 2000 Camry and reports success.

A printable window-switch trim documented by the original creator for 1993-1997 Corolla Toyota Corolla fitment. North-American seventh-generation fitment is explicit.

A printable upper glovebox organizer documented by the original creator for 2009-2015 Toyota Prius fitment. Source only speculates XW20 compatibility

Replacement knob for the FJ Cruiser heater and air-conditioning controls, retained with an M3 socket-head screw.

Replacement storage-box insert for the small opening below the outer dashboard vent, designed from a 1986 pickup.

Two-piece replacement knobs for the dashboard heater controls, with contrasting insert pieces for the indicator markings.

Replacement blanking cap for an unused rectangular dashboard switch opening.

Low-profile rear dash-camera mount that reuses the original headliner fastener and provides a pad for a Viofo-style camera.

Mount for replacing the sunglasses holder with a six-switch sPod controller on vehicles without crawl control.

Two dashboard inserts: one holds a replacement accessory-power socket or USB charger, and the other accepts a 52 mm auxiliary gauge.