Toyota 4Runner 3rd Gen 3D-printable parts

Left- and right-hand adapter plates for mounting 6.5-inch rear speakers in the original rear-door positions.

Four-position switch panel for the cubby in the later centre console, designed for the 1998–2000 console layout and original-style switches.

Replacement trim cover for the fastener in an interior grab handle, modelled from a 1998 vehicle.

Four mounting pieces for suspending fishing rods inside the cargo area using a 27-inch length of half-inch PVC pipe.

Replacement body-pressure vent with sliding closure, fixed-cover and drain-tube versions.

Protective pocket that restores a key-ring attachment point to a remote fob with a broken mounting loop. The source was designed around a 1999 remote.

Adapter for installing the later 3.4-litre mass-airflow tube in the earlier air-cleaner housing while retaining the original intake hose position.

Replacement bushings and keeper for the upper rear-hatch gas-strut mounting pin, with factory-style and revised versions.

Clip-on brace that holds the rear hatch fully open when worn gas struts can no longer support it.

Multi-piece phone mount that replaces the dashboard clock insert. Files include stud and printed-ball mounting options

Replacement bushing that removes excess play from the gear-shift lever.