Toyota 4Runner 1st Gen 3D-printable parts

Replacement blanking cap for an unused rectangular dashboard switch opening.

Replacement 10 mm square plastic body grommet for number-10 screws used on exterior trim such as side-marker lamps.

Replacement threaded knob for releasing and folding the rear seat.

Replacement retaining clip for the dashboard heating and ventilation controls.

Dashboard switch-opening adapter for an RJ45 keystone inline coupler, supplied in standard-snap and tight-snap versions.

Replacement clear lens for the interior light above the rear deck.

Replacement retaining clip for the removable-roof B-pillar trim.

Two-piece sliding cup holder that installs in the original ashtray bracket, with alternative threaded rear pieces for different bracket wear.

Replacement clip that secures the front grille to the body.

Replacement four-position ignition-wire separator that clips to the timing cover on vehicles equipped with the 3VZ-E engine.