Toyota Tacoma 1st Gen 3D-printable parts

Replacement trim cap for the screw opening in the interior door-handle surround, modelled from a 2002 vehicle.

Clip-in adapter for fitting a dual-USB extension socket into a factory dashboard switch opening without modifying the original trim.

Replacement latch for the sliding rear window, confirmed by the creator on 1996 and 1998 vehicles.

Clip-on holder for a compact Bluetooth headset, shaped for the dashboard vents used from 2001–2004.

Pair of twist-on mounts for securing a full-size flashlight between 10 mm headrest posts.

Replacement passenger-side clip that secures the interior door handle to its release cable, modelled from a 2003 vehicle.

Flexible replacement tabs for the factory cup holder when the original elastomer pieces have crumbled.

Single-DIN dashboard insert supplied as a plain storage pocket and as a panel for two compact voltmeters and a switch.

Press-fit replacement knob for the heater, fan-speed or airflow-control shafts on 2000–2004 vehicles.

Dashboard mount that locates a ScanGauge in the ashtray opening of later first-generation vehicles.

Hand tool that engages the manual front-hub dial to make locking and unlocking easier, including while wearing gloves.

Magnetic phone-mount base that replaces the upper driver-side grab-handle screw cover on 1997–2004 vehicles.

Workshop drivers for installing the driver- and passenger-side axle seals in the 7.5-inch front differential. Quarter-inch and half-inch extension-drive variants are included.

Replacement cap for the windscreen-washer fluid reservoir, modelled and tested on a 2001 vehicle.

Replacement plastic screw-retaining clip for the removable panel below the headlamp on 1996–2000 vehicles.

Replacement clip for securing the front turn-signal assembly, with provision for an M3 retaining screw.