Toyota Land Cruiser 80 Series 3D-printable parts

Three ashtray-replacement panel variants for adding rear-seat USB outlets, including switched and mirrored switched layouts.

Factory-style switch-blank panel for a flush-mounted combined USB and 3.5 mm auxiliary extension socket.

Replacement latch for the storage box between the front seats.

Blanking cover for the third-row ashtray opening when the original tray cannot be retained.

Middle- and side-vent repair inserts that replace crumbled pivot plates and provide new pins for drilled vent vanes.

Workshop socket for removing and installing the radio-antenna retaining nut.

Workshop socket for adjusting the differential side-bearing nut, modelled for a 1991 vehicle.

Rear support bracket for the power-seat threaded drive rod. The creator recommends full infill and notes that the centre bore may need adjustment.

Replacement latch for the fuel-filler door.

Deeper replacement pocket for the opening above the stereo, with a rear cable pass-through.

Three cup-holder insert variants for the square centre-console opening, including a larger rounded recess and a version with an accessory slot.

Replacement blanking plug for unused rectangular dashboard switch positions.

Replacement release lever for the lower tailgate, supplied with editable STEP source. The spline fit may need adjustment for individual printers.

Hands-free funnel that screws into the 37 mm by 3 mm-pitch oil-filler opening on the 1FZ-FE engine, keeping it seated above the rocker-cover baffle.

Threaded replacement cap for the power-seat drive screw.

Panel for installing a USB socket beside the rear-heater switch or in place of the coin holder in the centre console.

Interference-fit insert for the opening above the radio, with interchangeable mounts for a hands-free microphone and magnetic phone holder. The revised body includes pockets for two 5/16 by 1/8 inch retaining magnets.