Toyota Supra 3D-printable parts

Two-piece dashboard-trim mount for securing a Baofeng UV-5R handheld radio in the fifth-generation Toyota GR Supra, with a fitted trim clip and separate radio cradle.

Clip-in insert for the fifth-generation Toyota GR Supra centre-console cupholder, using the factory spring-loaded tabs and supplied in plain and accessory-cutout variants.

Three-piece fitted bass-reflex port and protective speaker-mesh set for the fifth-generation Toyota Supra rear subwoofer enclosure, designed to vent into the boot and reduce bass resonance.

Two fitted dashboard-trim mounts for the fifth-generation Toyota GR Supra, supplied in angled and flat versions for attaching a MagSafe charging puck.

Workshop alignment tool for centring the clutch disc on a Toyota Supra 2JZ and W58 transmission combination before the pressure plate is tightened.

Adapter for installing Audi switch 8D0941563 in the right-hand-drive Toyota Supra Mk4 right-side centre-panel switch position

Adapter that uses the factory three-point front-speaker mounting holes in a fourth-generation Toyota Supra to install a four-inch speaker without modifying the original enclosure

Replacement blanking cover for the centre or left switch opening in the 1993–1998 Toyota Supra JZA80 centre console.

Replacement clip for securing the fourth-generation Toyota Supra headliner using hook-and-loop fastener material

Modular replacement for the third-generation Supra ashtray, combining a side-positioned gauge pod with a choice of 100 mm or 125 mm storage pocket and the required back plate and spacer.

Replacement moving latch for the third-generation Supra centre-console cup holder. Light sanding or cleanup may be needed for smooth movement.

Replacement left and right lower-back finish trims, vibration-isolating end pads and optional mounting nut for the facelift third-generation Supra centre taillight panel. Use strong, vibration-resistant filament for the trims, soft TPU for the pads, and provide a separate watertight seal at the outer mounting holes.

Replacement retaining clip for the interior door trim of the second-generation Toyota Supra, modelled for a 1985 car.

Replacement interior trim panel surrounding the ignition switch on the second-generation Celica Supra.

Replacement M5 locking nut for the second-generation Celica Supra fog-light adjustment assembly.

Replacement ball connector for the 1984–1986 Celica Supra fog-light adjustment assembly, reported successfully printed and fitted by its designer.

Replacement front-grille clip for the second-generation Celica Supra, using a short piece of filament as the transverse retaining pin.

Mirrored left- and right-hand replacement radiator-support extensions for the second-generation Celica Supra, modelled from an original part and reference photographs.